|Date Added:||28 October 2007|
|File Size:||5.4 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
The images below illustrate possible power supply screw locations. The computer should automatically recognize the additional memory when you turn on the computer.
How does HP install software and gather data? Remove the four Phillips screws that secure the fan to the chassis, rotate the top of the fan forward, and then remove the hp compaq 5008 mt from the chassis. When replacing the hp compaq 5008 mt, use a battery equivalent to the battery originally installed on the computer. Be sure the side with hp compaq 5008 mt access panel is facing up. Connect the power cable 1 and data cable 2 to the rear of the optical drive. Keep cables away from major heat sources like the heatsink.
Apply the thermal grease provided in the spares kit to the top of the processor and install the heat sink atop the processor. Drives The computer supports one optical drive and one hard drive. Not all features listed in this guide are available on all computers.
A sharp bend can break the internal wires. Notes about your system: Use the lever to maneuver the square clip on the opposite side on the heat sink 3 free from the tab on the heat sink bracket.
HP Compaq B Specs – CNET
To reduce the risk of personal injury:. The system will not operate properly if you install unsupported DIMMs. Press the tabs near the bottom hp compaq 5008 mt both sides of the switch holder 1 to disengage it from the chassis, rotate the bottom of the switch upward 2and then pull it away from the chassis while guiding the wires through the hole in the chassis. PCI Express x1 expansion slot.
Slide the cover about 2. Avoid exposing a hard drive to liquids, temperature extremes, or products that have magnetic fields such as monitors or speakers.
HP Customer Support – Software and Driver Downloads
System Board Drive Connections Refer to the following illustration and table to identify the system board drive connectors. Type 3 Battery Holder Pull back on the clip 1 that holds the battery in place, then remove the battery hp compaq 5008 mt. Pull each of the three side tabs that secure the front bezel to the computer, to release the front bezel. Please try again shortly. Never crease or bend a Hp compaq 5008 mt data cable tighter than a 30 mm 1. Do not rely on components like the drive cage, power supply, or computer cover to push cables down into the chassis.
Chipset is a set of integrated circuits that have a specific purpose in a computer system, a group of microchips used together to perform a single task.
Replacing an Optical Drive Hp compaq 5008 mt install an optical drive:.
Let HP identify any out-of-date or missing drivers and software. Select the desired files and choose ‘Download files’ to start a batch download.
Not sure which drivers to choose? Do not remove a drive while the computer is on or in standby mode.
RAM & SSD Upgrades | HP – Compaq HP B Microtower |
Remove the four torx screws 1 that secure the heat sink to the system board. To reduce risk of personal injury from hot surfaces, allow the internal hp compaq 5008 mt components to cool before touching.
Vompaq the memory can be installed one module at a time, the best performance comes from using matched pairs of modules.