USB CARD READER UCR 61 DRIVER

Flaming or offending other users. It should look like that after the mod: Link SMD pads labelled as R I think you can remove this resistor by ripping it from the board, but it’s not good for tracks, and they must remain good. Unsolder the resistor by heating one of its ends at time, lifting it a bit using a sharp knife or tweezers. The behaviour of Active LED will be somewhat strange – it will light up only if the system detected the device, so if you “safely remove” it, light will go out

Uploader: Taurn
Date Added: 22 March 2008
File Size: 25.92 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 50156
Price: Free* [*Free Regsitration Required]

Think of it as of a small computer, which converts data between cards and USB. LED5 – MS card.

Syntax UCR 61 USB Card Reader | eBay

Advertisements or commercial links. Click here to review our site terms of use. There is a problem: Back to home page. Solder a black wire to remaining LED1 hole.

You probably can use it in Windows by installing this driver i haven’t tried it! R35 should be also near Ohm. I think you can remove this resistor by ripping it from the board, but it’s not good for tracks, and they must remain good.

Link SMD pads labelled as R Now remove cables from it, so it’ll move along a LED wires. Please submit your review for ucr Flaming or offending other users. First, remove two screws from the reader. Another picture of everything inside: You should see from the corner upwards a SMD resistor used as a jmper codea SMD pads for resistor and a capacitor.

ECS IC Card Reader UCRS2B Specs – CNET

Connect R28, Ohm goes to R38 if there isn’t. Looking to front of the reader: Once reported, our staff will be notified and the comment will be reviewed.

Related Driver:  AGFA DUOSCAN F40 DRIVER FOR WINDOWS 7

The behaviour of Active LED will be somewhat strange – it will light up only if the system detected the device, so if you “safely remove” it, light will go out It should look like that after the mod: LED3 – is a CF card indicator.

LED2 lights up when SmartMedia slot is active.

Sexually explicit or offensive language. In this document Usn show how to make this reader more universal and how to add some visual hacks.

Login or create an account to post a review. It means thay you’ll be limited to only one computer with a special driver, it’ll be impossible to use this reader in jsb computer with no drivers.

Syntax UCR 61 USB Card Reader

Unsolder active LED wires. On a board, near these cables, you will see a 5 LED places. Cut this glue out from both wires. You have to remove this resistor with jcr and connect the pads below in fact you’re changing a readr state of Neodio’s pin If there’s no resistor in R26, there must be about Ohm. R54 must be about Ohms. You can re-make front panel for all 5 LEDs, like mine: